![]() ![]() There is probably difference if you buy these modules preconfigured by victron or yourself directly. I will try RC candidate version as well but doubt it will do anything. There is no settings setupable in CCGX, you have no control over connection from that side. I have modified zigbee modules to 9,6k baud rate and it connects now though com port and computer with CG SW.ĬCGX 2.84 ignores meter. So Carlo ET112 has default 9,6k baud rate, no parity and 1 stop bit. Now whats important is to match parity and baud rate of modules with carlo gavazzi otherwise it doesnt work for me. You should see TX RX LED to blink on both modules as sides try to communicate (carlo software tries to find device f.ex.) Fast blink indicates connection to zigbee network is not made. Slave module in my case RS485 one should blink slowly on activity LED. In my case transferring configuration to slave router modules doesnt work so I edited config in them to End point. Its easy when its done, you need USB rs485 adapter to configure rs485 zigbee module.Īs other threads mention, one module should be coordinator, that one has solid activity LED. I mostly understand how these modules works, blink codes etc, have DTK software, Carlo Gavazzi software.Īfter lot of try and error, I have been able to configure zigbee modules to work with windows computer and carlo gavazzi software. I have correct zigbee modules, DRF2658C, DRF2659C both have firmware v8.8. I am really struggling with et112, zigbee and ccgx. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |